Mojave MA-301fetVG, Multi-pattern Large Diaphragm Solid State Condenser Vintage Grey

The MA-301fet is a multi-pattern large diaphragm, solid-state condenser microphone. Based upon the popular MA-201fet designed by David Royer, the MA-301fet adds a 3-position pickup pattern selector, a15dB pad and a switchable bass roll-off.

Utilizing a 3-micron gold-sputtered capsule, high-quality Jensen audio transformer, military-grade FET and custom designed low-noise resistors, the MA-301fet performs at a level reminiscent of some of the best loved classic condenser microphones. Each MA-301fet microphone is carefully tested and evaluated, then packaged in its protective case with a professional grade shockmount.

:

1. Multi-pattern: Cardioid, Omnidiectional, Figure-eight (Bi-directional)
   Switchable 15dB pad
   Switchable Bass Roll-off
   Hand-selected 3-micron 1 ″ capsule
   Jensen audio transformer
   Military-grade FAT
   Custom designed low-noise resistors
   Ultra clean signal pathRecommended Applications:
2. Vocals
   Voice Over and Broadcast
   High SPL sources, such as Kick Drums and Bass Guitar Amps
   electric guitar
   Piano
   Drum Overheads, Drum RoomsTECHNICAL DATA
   TRANSDUCER TYPE: Externally polarized, pressure gradient capacitor - double diaphragm.
   DIAPHRAGM: 1-inch diameter, gold sputtered
   DIAPHRAGM THICKNESS: 3 microns
   POLAR PATTERN: 3 patterns; omni, cardioid and figure-8
   FREQUENCY RESPONSE: 20 Hz to 20 KHZ, +/- 3 dB at “flat” setting of bass cut
   switch. Bass cut switch provides 6 dB per octave attenuation below
   100 Hertz in "cut" setting
   SENSITIVITY: -40.5 dB, re. 1V / pa
   MAXIMUM SPL: 120 dB with pad off, 135 dB with pad on.
   DISTORTION: <1% @ 120 dB SPL, <3% @ 134 dB SPL with pad off
   <1% @ 134 dB SPL, <3% @ 148 dB SPL with pad on
   SELF NOISE: 14dB nominal, not to exceed 16dB (A weighted)
   PAD: 15 dB
   BASS CUT: 6 dB per octave below 100 hertz.
   IMPEDANCE: 550 ohms, transformer balanced (Jensen)
   POWER: 48VDC phantom power; current 1.2 mA
   DIMENSIONS AND WEIGHT:
   Carrying case with microphone, shock mount: 10 ″ x 9 ″ x 4.5., 4 lbs.
   Microphone: 7 5/8 ″ X 2 ″ (194mm x 51mm), 1 lb. (0.45Kg)