Mojave MA-200SN, Large Diaphragm Tube Condenser

The MA-200 is a large diaphragm, vacuum tube condenser microphone with a fixed cardioid pattern. Born to a lineage of fine microphone designs by David Royer, the MA-200 gives warm, full-bodied reproductions of vocals and instruments, with none of the shrillness and high frequency distortion artifacts that are often encountered with modern condenser microphones.

Utilizing hand-selected 3-micron capsules, high-quality Jensen audio transformers and military-grade JAN 5840 vacuum tubes, the MA-200 performs at a level reminiscent of some of the best-loved classic condenser microphones. The MA-200 power supply can be set for 115V and 230V, 50 or 60 Hz, through an internal switch (100V is also available). Each MA-200 microphone, power supply and cable set is burned in for 24 hours, carefully tested and evaluated, then packaged in its protective case-within-a-case.

Features:

1. Hand-selected 3-micron capsule
   Jensen audio transformer
   Military grade JAN 5840 vacuum tube
   Internal switchable power supply voltage
   Ultra clean signal pathRecommended Applications:
2. Use anywhere you would use an expensive, large diaphragm tube microphone. Vocals
   Voice Over and Broadcast
   Acoustic Instruments
   Piano
   Drum Overheads, Drum Rooms
   Orchestral Recording
   Choral RecordingTECHNICAL DATA
   TRANSDUCER TYPE: Externally excited capacitor type
   DIAPHRAGM: 1-inch diameter, gold sputtered
   DIAPHRAGM THICKNESS: 3-microns
   POLAR RESPONSE: Cardioid
   FREQUENCY RESPONSE: 20 Hz - 20 kHz, +/- 3dB
   SENSITIVITY: -37dB re 1V / pa
   MAXIMUM SPL: 120dB
   DISTORTION: head amp only, <1% @ 117dB SPL, <3% @ 125dB SPL
   SELF NOISE: 14db nominal, not to exceed 16db (A Weighted)
   IMPEDANCE: 200 ohms, balanced using an output transformer
   VACUUM TUBE: 5840 - pentode tube wired for triode operation
   POWER REQUIREMENTS: 100-120VAC; 220-240VAC, 50 or 60 Hz. Power consumption approx. 10 watts.
   DIMENSIONS AND WEIGHT:
   Carrying case with microphone, power supply, shock mount
   and cables: 13 lbs.
   Microphone: 7 5/8 ″ X 2 ″, 1 lb.